/
Delivery & fitting/
Decal fitting guide
LR Designs / workshop guide
A better fit.
A better finish.
Take your time, prepare the surface and give the adhesive time to bond. Follow the LR Designs fitting tips below.
01
Start at room temperature
Apply the decals at room temperature. Pre-warm with a hair dryer or heat gun if necessary.
02
Clean every surface
Clean the surface with contact cleaner or isopropanol alcohol. This includes new plastics.
03
Apply evenly
Press the decal firmly and evenly, working outwards in the direction you are fitting it.
04
Work around the curves
Use gentle heat to help the decal follow complex curved areas.
05
Check the edges
Trim only where necessary and make sure every edge is firmly bonded.
06
Warm each fitted decal
Apply heat after fitting to help the decal mould and the adhesive bond.
07
Give it 24 hours
Allow 24 hours at room temperature for the decal to bond before use.